Difference between revisions of "AIW assembly"
From DIDEAS Wiki
m |
m |
||
Line 1: | Line 1: | ||
− | *[[Upd_pcb | PCB]] [[Aiw_hardware | Hardware]] [[AIW_assembly | Assembly]] [[PFMENU DOCS | PFCmdMenu]] [[iochan | + | *[[PF Top Nav]]; [[Upd_pcb | PCB]]; [[Aiw_hardware | Hardware]]; [[AIW_assembly | Assembly]] [[PFMENU DOCS | PFCmdMenu]] [[iochan]] |
− | *[[Upd_2x0_218_controller | SC/MC 218]] [[Upd_2x0_217_power_board| FET 217]] | + | *PCA : [[Upd_2x0_218_controller | SC/MC 218]] [[Upd_2x0_217_power_board| FET 217]] [[Upd_219_imu | IMU219]] [[Wip4a-spi | Swiffy]] [[Rev200_mods]] |
+ | *PFCMD : [[PFMENU_DOCS | SC]]; [[PFMENU_DOCS_MC | MC]]; [[PFCMD_PY]]; [[Pf_calb_table_py]]; [[Virtual spring test]]; [[PF1_Code_History]]; [[PF EEPROM]] | ||
+ | |||
+ | *SERIES: [[AK-WB1 | S01]] [[AK-WB2 | S02]] [[AK-TEST1 | S03]] [[wow_left]] [[wow_right]] | ||
*SCREWS | *SCREWS |
Revision as of 18:43, 3 July 2009
- PF Top Nav; PCB; Hardware; Assembly PFCmdMenu iochan
- PCA : SC/MC 218 FET 217 IMU219 Swiffy Rev200_mods
- PFCMD : SC; MC; PFCMD_PY; Pf_calb_table_py; Virtual spring test; PF1_Code_History; PF EEPROM
- SCREWS
- side plates (sholder screws) : 2.5mm
- K2 spring to ball nut / actuator : 2mm
- K3 spring : 7/64"
- front / back cover : 5/64"
- belt tension adjust : 50 mills
BT / Swiffy
- Using FUP1 board, interface 9pin Rev 200 FUP to BT FUP
- Connect BT to FUP1 w/ 5pin straight cable, into the RED (straight) header.
- run BT communications wire
before K3
- insert both programming cables
- wait to install K3 last, VHB copper spreader to K3 (might fall out otherwise)
- red lock tight pyramid tube adapter into WOW pack
- connect BT mod to flexF midpoint, make sure to correct module for left vs right.