Revision as of 04:43, 27 October 2009

• PF Users Navigation:
• PCB; Lifefix_users; Pf_users; benchtest_users; CalibFix Users; Hardware; Assembly ; iochan ;
• PCA : PCB ; AKENC SC/MC 218  ; FET 217 ; IMU219 ; Swifi ; Rev200_mods  ; PCA Inventory
• Special Commands to the Ankle (PFCMD) : State Controller Commands; Motor Controller Commands; Python Examples; IMU Commands ;PFCMD_PY; Pf_calb_table_py; Virtual spring test; PF EEPROM
• DOC: Pf_users; Powerfoot Keyboard User Interface; Steps for Manual Tuning; "Dashboard" Program For Assisting with Tuning
• NEW (CEB) WIKI
• Torque Feedback Controller Guide

Edit

• pser2h ; pser2h-b ; pser1 ; FUPs ; ldwash1 ; ldwash2 ; ; Vclamp8 ; dclamp1 ; dclamp2 ; wip4a-spi ; wip4c

Swifi

ECOs

1. PFB1, PFB2 land patterns need to be reversed.
2. PFUP1 should call out a RA header.

assembly status / build variations

• 1 - 10-24-09 : assembly completed, firmware loaded, seems to work well.
  • local ISP connector populated w/right angle.
  • populated the 9x1mm vertical connectors (PFB1, PFB2) backwards to correct for incorrect land pattern.

• 2

assembly files

• SCH
• power supply sch
• BOM
• TOP
• BOT
• Gerbers GCP9 viewer
• partslist

future changes

• put a 0 ohm shut at the output of the switching power supply - allows testing of the power supply and measurement of current.

known issues

• connecting PSER1c to the right angle SC port, appears to interfere with MPD comm
  • need to think about the resistors used to or the signals - or install larger resistors on PSER1c. The PSER is using 102 (1k) resistors.
  • WIP4c also uses 1k on its TX signal - PSER1c should increase to 5k? but worry that could cause problems w/use at high speed....