Revision as of 03:50, 7 August 2009

PF Users Navigation:

• PCB; Lifefix_users; Pf_users; benchtest_users; CalibFix Users; Hardware; Assembly ; iochan ;
• PCA : PCB ; AKENC SC/MC 218  ; FET 217 ; IMU219 ; Swifi ; Rev200_mods  ; PCA Inventory
• Special Commands to the Ankle (PFCMD) : State Controller Commands; Motor Controller Commands; Python Examples; IMU Commands ;PFCMD_PY; Pf_calb_table_py; Virtual spring test; PF EEPROM
• DOC: Pf_users; Powerfoot Keyboard User Interface; Steps for Manual Tuning; "Dashboard" Program For Assisting with Tuning
• NEW (CEB) WIKI
• Torque Feedback Controller Guide

Edit

SC/MC 2x0-218 PCA

200-218-001

• 8-6-09 : found on bench. MC doesn't seem to be powered (unable to program)
• (date unknown - June???) location AK-WB2

200-218-003

• 4-27-09 : will start testing.
• needs R233 and R222 shorted (solder ball)

200-218-005

• location (IW)
• 4-16-09 : SHORTED R233 and R222 to enable local VBAT MEASUREMENT. DONT CONNECT EXTERNAL BATTERY CABLE
• location ceb benchtest (MIT), used for code dev

200-218-006

• 4-25-09 : has problem with MC reset
• 4-2-09 : start bench test at 3:10am (w/217-006), finished 2pm - works well!

200-218-007

• 4-6-09 : start bench test at 2am; finished 9:10pm (w/217-007) works well.

200-218-008

• location (6-26-09) - used for CEB code development at lab

200-218-009

• location AK-WB1 ???

200-218-010

• 4-2-09 : ran bench test for 1.5 hrs with 217-010

ECOs

Battery voltage measurement

• solder ball / zero ohm resistor across R222 and R233

EC30-MILE 5V encoder drive

• Disconnect pin6 of D10 from the signal Hall.C;

• On J10 (5pin x 1.25mm header) install a 4.7k 0603 resistor between pin 4 (5VDMC) and pin 3 (HALL_C).

• Replace R86 with a 220 ohm 0402