Difference between revisions of "Pser2h"
From DIDEAS Wiki
m |
m |
||
Line 7: | Line 7: | ||
*EEPROM lacks pull up on EECS | *EEPROM lacks pull up on EECS | ||
*Need 10K resistor pack for RE2 (has 1k) | *Need 10K resistor pack for RE2 (has 1k) | ||
+ | *the ISP select should switch the power supply also. eg the ISP is connected to PORT1 power and gnd, but if there is nothing connected - the realice thinks that nothing is connected. | ||
+ | * will need a way to latch the present ISP selection as when the SERIAL port is close, the value can't be changed. | ||
+ | * also want an LED to indicate which port is selected. | ||
+ | |||
==ECO== | ==ECO== | ||
*cut trace to RE2, pin3 | *cut trace to RE2, pin3 | ||
Line 16: | Line 20: | ||
** has 1 ISP connector and uses ISP switch | ** has 1 ISP connector and uses ISP switch | ||
** after addition of EEPROM - doesn't enumerate | ** after addition of EEPROM - doesn't enumerate | ||
+ | ** need to re-assembly to use 2 ISP connectors. | ||
+ | |||
* 2 - assembled 10-16-09; | * 2 - assembled 10-16-09; | ||
**has 2 ISP connectors. | **has 2 ISP connectors. |
Revision as of 23:40, 18 October 2009
PF Users Navigation:
- PCB; Lifefix_users; Pf_users; benchtest_users; CalibFix Users; Hardware; Assembly ; iochan ;
- PCA : PCB ; AKENC SC/MC 218 ; FET 217 ; IMU219 ; Swifi ; Rev200_mods ; PCA Inventory
- Special Commands to the Ankle (PFCMD) : State Controller Commands; Motor Controller Commands; Python Examples; IMU Commands ;PFCMD_PY; Pf_calb_table_py; Virtual spring test; PF EEPROM
- DOC: Pf_users; Powerfoot Keyboard User Interface; Steps for Manual Tuning; "Dashboard" Program For Assisting with Tuning
- NEW (CEB) WIKI
- Torque Feedback Controller Guide
Edit pser2h ; pser2h-b ; pser1 ; FUPs ; ldwash1 ; ldwash2 ; ; Vclamp8 ; dclamp1 ; dclamp2 ; wip4a-spi ; wip4c
known issues
- EEPROM lacks pull up on EECS
- Need 10K resistor pack for RE2 (has 1k)
- the ISP select should switch the power supply also. eg the ISP is connected to PORT1 power and gnd, but if there is nothing connected - the realice thinks that nothing is connected.
- will need a way to latch the present ISP selection as when the SERIAL port is close, the value can't be changed.
- also want an LED to indicate which port is selected.
ECO
- cut trace to RE2, pin3
- run wire from RE2.3 to UE1.1
serial numbers
- 1 - assembled 10-15-09; tested both isolated serial port; ISP not programed.
- has 1 ISP connector and uses ISP switch
- after addition of EEPROM - doesn't enumerate
- need to re-assembly to use 2 ISP connectors.
- 2 - assembled 10-16-09;
- has 2 ISP connectors.
- after addition of EEPROM - doesn't enumerate
assembly mods
- RE2 will be 10k not 1k
- 4.7uF replaced w/10uF