Upd 2x0 218 controller
From DIDEAS Wiki
Contents
ALL BOARDS NEED R233 and R222 shorted (solder ball)
SC/MC 2x0-218 PCA
200-218-001
- location AK-WB2
200-218-003
- 4-27-09 : will start testing.
- needs R233 and R222 shorted (solder ball)
200-218-005
- location (IW)
- 4-16-09 : SHORTED R233 and R222 to enable local VBAT MEASUREMENT. DONT CONNECT EXTERNAL BATTERY CABLE
- location ceb benchtest (MIT), used for code dev
200-218-006
- 4-25-09 : has problem with MC reset
- 4-2-09 : start bench test at 3:10am (w/217-006), finished 2pm - works well!
200-218-007
- 4-6-09 : start bench test at 2am; finished 9:10pm (w/217-007) works well.
200-218-008
- location (6-26-09) - used for CEB code development at lab
200-218-009
- location AK-WB1 ???
200-218-010
- 4-2-09 : ran bench test for 1.5 hrs with 217-010
ECOs
Battery voltage measurement
- solder ball / zero ohm resistor across R222 and R233
EC30-MILE 5V encoder drive
- Disconnect pin6 of D10 from the signal Hall.C;
- On J10 (5pin x 1.25mm header) install a 4.7k 0603 resistor between pin 4 (5VDMC) and pin 3 (HALL_C).
- Replace R86 with a 220 ohm 0402