Difference between revisions of "Wip4c"
From DIDEAS Wiki
m (→assembly modifications) |
m |
||
Line 4: | Line 4: | ||
[[Swifi]] | [[Swifi]] | ||
− | =assembly | + | =ECOs= |
+ | |||
+ | =assembly status / build variations = | ||
*1 - local ISP connector populated w/right angle. | *1 - local ISP connector populated w/right angle. | ||
− | ** populated the | + | ** populated the 9x1mm vertical connectors (PFB1, PFB2) backwards to correct for incorrect land pattern. |
*2 | *2 |
Revision as of 04:04, 26 October 2009
- PF Users Navigation:
- PCB; Lifefix_users; Pf_users; benchtest_users; CalibFix Users; Hardware; Assembly ; iochan ;
- PCA : PCB ; AKENC SC/MC 218 ; FET 217 ; IMU219 ; Swifi ; Rev200_mods ; PCA Inventory
- Special Commands to the Ankle (PFCMD) : State Controller Commands; Motor Controller Commands; Python Examples; IMU Commands ;PFCMD_PY; Pf_calb_table_py; Virtual spring test; PF EEPROM
- DOC: Pf_users; Powerfoot Keyboard User Interface; Steps for Manual Tuning; "Dashboard" Program For Assisting with Tuning
- NEW (CEB) WIKI
- Torque Feedback Controller Guide
- pser2h ; pser2h-b ; pser1 ; FUPs ; ldwash1 ; ldwash2 ; ; Vclamp8 ; dclamp1 ; dclamp2 ; wip4a-spi ; wip4c
ECOs
assembly status / build variations
- 1 - local ISP connector populated w/right angle.
- populated the 9x1mm vertical connectors (PFB1, PFB2) backwards to correct for incorrect land pattern.
- 2
assembly files
future changes
- put a 0 ohm shut at the output of the switching power supply - allows testing of the power supply and measurement of current.