Difference between revisions of "AIW assembly"
From DIDEAS Wiki
m |
m |
||
Line 12: | Line 12: | ||
[[AIW_preassembly]] | [[AIW_preassembly]] | ||
− | + | =BT / Swiffy= | |
+ | *Using FUP1 board, interface 9pin Rev 200 FUP to BT FUP | ||
+ | **Connect BT to FUP1 w/ 5pin straight cable, into the RED (straight) header. | ||
*run BT communications wire | *run BT communications wire | ||
Revision as of 03:29, 2 April 2009
- SCREWS
- side plates (sholder screws) : 2.5mm
- K2 spring to ball nut / actuator : 2mm
- K3 spring : 7/64"
- front / back cover : 5/64"
- belt tension adjust : 50 mills
BT / Swiffy
- Using FUP1 board, interface 9pin Rev 200 FUP to BT FUP
- Connect BT to FUP1 w/ 5pin straight cable, into the RED (straight) header.
- run BT communications wire
before K3
- insert both programming cables
- wait to install K3 last, VHB copper spreader to K3 (might fall out otherwise)
- red lock tight pyramid tube adapter into WOW pack
- connect BT mod to flexF midpoint, make sure to correct module for left vs right.