Difference between revisions of "Upd 219 imu"
From DIDEAS Wiki
m |
m |
||
Line 1: | Line 1: | ||
− | [[Upd_pcb | UPD PCBs]] [[ | + | *[[Upd_pcb | UPD PCBs]] |
+ | |||
+ | *PCA : [[Upd_2x0_218_controller | SC/MC 218]] [[Upd_2x0_217_power_board| FET 217]] [[Upd_219_imu | IMU 219]] [[Wip4a-spi | Swiffy]] [[Rev200_mods]] | ||
+ | |||
+ | |||
<br> | <br> | ||
[[PFMENU DOCS]] [[Aiw_hardware]] [[iochan]] [[AIW_assembly]] | [[PFMENU DOCS]] [[Aiw_hardware]] [[iochan]] [[AIW_assembly]] |
Revision as of 20:38, 26 June 2009
- PCA : SC/MC 218 FET 217 IMU 219 Swiffy Rev200_mods
PFMENU DOCS Aiw_hardware iochan AIW_assembly
Contents
IMU
1
- 6-23-09 : seems to be working
- 1-24-09 : boots and can reprogram - this will be the IMU development device.
- 1-24-09 : removed broken jumper wires from GND to R28. Shorted Q4 gate to ground.
- 1-24-09 : is missing pushbutton switch and is missing PB pad. Remain 3 pads don't seem to be enough to switch the system on.
2
- 6-23-09 : seems to be working with 'blue' cable w/red and black marks on connector
- 1-24-09 : was able to erase and reprogram.
- 1-24-09 : system is getting 3.3V w/push button - however, unable to program over protected segments
todo
- discuss with DY how to recover. Possibly sent back to UPD.
3
- 6-23-09 : seems to be working. appears to have been relabled with #1 (despite the #3 appearing on two ICs.)
- 1-24-09 : switching regulator gets voltage w/PB, however, 3.3V is unchanged.
todo
- replace switcher U7