Lifefix log
From DIDEAS Wiki
PF Users Navigation:
- PCB; Lifefix_users; Pf_users; benchtest_users; CalibFix Users; Hardware; Assembly ; iochan ;
- PCA : PCB ; AKENC SC/MC 218 ; FET 217 ; IMU219 ; Swifi ; Rev200_mods ; PCA Inventory
- Special Commands to the Ankle (PFCMD) : State Controller Commands; Motor Controller Commands; Python Examples; IMU Commands ;PFCMD_PY; Pf_calb_table_py; Virtual spring test; PF EEPROM
- DOC: Pf_users; Powerfoot Keyboard User Interface; Steps for Manual Tuning; "Dashboard" Program For Assisting with Tuning
- NEW (CEB) WIKI
- Torque Feedback Controller Guide
LF #1 LOG
- 09-09-17 10:00 - restarted but stopped due to broken bolt after 44 cycles
- 09-09-17 09:00 - stopped due to annoying neighbors.
- 09-09-17 04:40 - started 10000 passes
- 09-09-17 04:30 - started 237 passes
- 09-09-17 03:30 - ran a few hundred cycles during experiments.
- 09-09-17 03:00 - 3 incidences of max plantar, and re-phased the motor current
- 09-09-11 23:53 - stops after 4969 passes due to belt break, ball nut on floor, load washer hanging
- 09-09-11 21:00 - started LF_TEST_101
- 09-09-11 14:00 - LW tightened
- 09-09-11 03:00 - notice that LW has slipped - is no longer pre-loaded.
- 09-09-11 00:10 - during belt stress test, LF runs away and max plantar
- 09-09-10 23:30 - replaced broken belt; three ball screw balls fall out (from yesterday's over extension)
- 09-09-10 02:30 - stopped due to broken belt (3600 cycles)
- 09-09-10 00:30 - started LF_TEST100
- 09-09-10 20:00 - resonance experiments of inside only - excessive dors
- 09-09-10 16:00 - resonance experiments of full LF w/Kristin
LF_TEST_101
- appx 29 cyc per min
- has belt thresh
- full amplitude on drive motor
- thrust scale=3000N
LF_TEST_100
- appx 30 cyc per min
- full amplitude on drive motor
- thrust scale=3000N