Aiw hardware

• PCB Hardware

• ASSEMBLY NOTES / INSTRUCTIONS

• SCREWS
  • side plates (sholder screws) : 2.5mm
  • K2 spring to ball nut / actuator : 2mm
  • K3 spring : 7/64"
  • front / back cover : 5/64"
  • belt tension adjust : 50 mills

system

Proto 1

• wow_left

03-13-09 :New Thrust bearings, shim bearing sleeve, replaced out of spec large drive pulley, new NORGLIDE bushings & bolts, replace Bluetooth harness, replace battey power leads & flat cable connector on old rev control board. Needs new rev electronics for the show.

Proto 2

• wow_right

Proto 3

• proto3

Proto BAK

• protoBAK

gear system

• 9.6 est small diameter ?? . (15 teeth?), 5mm more
• ~25mm diameter - (40 teeth), 6mm bore
• w/belt 26.32mm diameter
• 35 mm spacing
• current ratio ~2.5
• large pulley radius could grow by 7.3mm (abs max) - although part of the pyramid is in the way. lathe to fix that.
• 39mm pulley has 62 teeth - for a ratio of 4.13!

battery packs

• WOW#1 - 12.5 amp fuse
• 22.29V -> 1.074AHr - paused to charge another.
  • 24.31V -> 0.183

• WOW#2 - 10 amp fuse
  • 22.62 -> 0.787 - not complete
  • 24.08V -> 25.16 -> .251Aht

• WOW#5 - 12.5 amp fuse
  • 22.62 -> 25.16 : 0.863 Ahr

• WOW#6 - 10 amp fuse
  • 22.34

bluetooth

• 100:001 : 8B (PDA -> right) "iwxxx1"
• 100:002 : 65 (PDA -> left) "default"
• 100:003 : DF (PDA #4
• 100:004 ??: 8E (PDA #5)
•  ???:??? : 18 (PDA #3)

• others are "Iwxxxx" or "iwxxx"