Difference between revisions of "Aiw hardware"
From DIDEAS Wiki
m (→Proto 2) |
m (→bluetooth) |
||
Line 65: | Line 65: | ||
* others are "Iwxxxx" or "iwxxx" | * others are "Iwxxxx" or "iwxxx" | ||
+ | |||
+ | *PCB dimensions : 2.14 x 1.5 x 0.3" | ||
+ | *box dimensions : 2.26 x 1.6 x 0.76" |
Revision as of 21:24, 17 February 2009
- SCREWS
- side plates (sholder screws) : 2.5mm
- K2 spring to ball nut / actuator : 2mm
- K3 spring : 7/64"
- front / back cover : 5/64"
- belt tension adjust : 50 mills
Contents
system
Proto 1
03-13-09 :New Thrust bearings, shim bearing sleeve, replaced out of spec large drive pulley, new NORGLIDE bushings & bolts, replace Bluetooth harness, replace battey power leads & flat cable connector on old rev control board. Needs new rev electronics for the show.
Proto 2
Proto 3
Proto BAK
gear system
- 9.6 est small diameter ?? . (15 teeth?), 5mm more
- ~25mm diameter - (40 teeth), 6mm bore
- w/belt 26.32mm diameter
- 35 mm spacing
- current ratio ~2.5
- large pulley radius could grow by 7.3mm (abs max) - although part of the pyramid is in the way. lathe to fix that.
- 39mm pulley has 62 teeth - for a ratio of 4.13!
pyramid_2008
Drive_assembly_2008
battery packs
- WOW#1 - 12.5 amp fuse
- 22.29V -> 1.074AHr - paused to charge another.
- 24.31V -> 0.183
- WOW#2 - 10 amp fuse
- 22.62 -> 0.787 - not complete
- 24.08V -> 25.16 -> .251Aht
- WOW#5 - 12.5 amp fuse
- 22.62 -> 25.16 : 0.863 Ahr
- WOW#6 - 10 amp fuse
- 22.34
charge
bluetooth
- 100:001 : 8B (PDA -> right) "iwxxx1"
- 100:002 : 65 (PDA -> left) "default"
- 100:003 : DF (PDA #4
- 100:004 ??: 8E (PDA #5)
- ???:??? : 18 (PDA #3)
- others are "Iwxxxx" or "iwxxx"
- PCB dimensions : 2.14 x 1.5 x 0.3"
- box dimensions : 2.26 x 1.6 x 0.76"