Difference between revisions of "Pf users"
From DIDEAS Wiki
m |
m (→SWIFI dataport) |
||
Line 2: | Line 2: | ||
=data collection= | =data collection= | ||
==SWIFI dataport== | ==SWIFI dataport== | ||
− | wifi_fast.py -i <ip address or name> -p <matlab listen port> -V <variable list filename> -F -f <log file name> | + | * wifi_fast.py -i <ip address or name> [-p <matlab listen port>] -V <variable list filename> -F -f <log file name> |
+ | ** -i - the IP address of the SWIFI. Typical 192.168.192.xx or "sw8" | ||
+ | ** -V specifies the format and names of the packets from the dataport. use : -V imu2.vlist | ||
+ | ** -p (optional), default is 9999 - use if multiple plotters running simultaniously. If not 9999, before starting matlab plotter, assign the variable "matlab_listen_port" to some value in the range of 9990 and 9999 | ||
+ | ** -F (optional) - flush the SWIFI buffer at startup. The buffer could be holding upto ~2 mins of the past data. | ||
+ | ** -f the base filename used for logging of the binary packet data, and ASC form of the packets. | ||
* sometimes at power up, SWIFI outputs garbage. The solution is to power cycle the SWIFI until it works. | * sometimes at power up, SWIFI outputs garbage. The solution is to power cycle the SWIFI until it works. | ||
− | + | ** this appears to be a baud rate problem - and is being corrected. | |
=init table= | =init table= |
Revision as of 16:23, 16 October 2009
PF Users Navigation:
- PCB; Lifefix_users; Pf_users; benchtest_users; CalibFix Users; Hardware; Assembly ; iochan ;
- PCA : PCB ; AKENC SC/MC 218 ; FET 217 ; IMU219 ; Swifi ; Rev200_mods ; PCA Inventory
- Special Commands to the Ankle (PFCMD) : State Controller Commands; Motor Controller Commands; Python Examples; IMU Commands ;PFCMD_PY; Pf_calb_table_py; Virtual spring test; PF EEPROM
- DOC: Pf_users; Powerfoot Keyboard User Interface; Steps for Manual Tuning; "Dashboard" Program For Assisting with Tuning
- NEW (CEB) WIKI
- Torque Feedback Controller Guide
data collection
SWIFI dataport
- wifi_fast.py -i <ip address or name> [-p <matlab listen port>] -V <variable list filename> -F -f <log file name>
- -i - the IP address of the SWIFI. Typical 192.168.192.xx or "sw8"
- -V specifies the format and names of the packets from the dataport. use : -V imu2.vlist
- -p (optional), default is 9999 - use if multiple plotters running simultaniously. If not 9999, before starting matlab plotter, assign the variable "matlab_listen_port" to some value in the range of 9990 and 9999
- -F (optional) - flush the SWIFI buffer at startup. The buffer could be holding upto ~2 mins of the past data.
- -f the base filename used for logging of the binary packet data, and ASC form of the packets.
- sometimes at power up, SWIFI outputs garbage. The solution is to power cycle the SWIFI until it works.
- this appears to be a baud rate problem - and is being corrected.
init table
known issues