Wow left
From DIDEAS Wiki
WOW proto2 (left)
- 4-20-09 : left ankle has #1, right ankle #2
- 4-18-09 : ankle becomes stuck at max plantarflexion. CEB repairs, finds no electrical problems. Code left unchanged.
- 4-2-09 : belt was loose, cause was 4 thrust bearing screws were loose. tightened belt, and 4x screws. used red LT on was of 4 -> the one closest to the "0" in Drive "10".
- 4-2-09 : replaced with rev 200 board set (#4 SC/MC and #4 power)
- 4-1-09 : discovered has drive assembly #10 (not #6)
- 4-1-09 : power board #5 TVS appears to have made contact with case causing solder and Cu trace to melt/vaporize.
- 2-13-09 :New Thrust bearings, shim bearing sleeve, replaced out of spec large drive pulley, new NORGLIDE bushings & bolts, replace Bluetooth harness, replace battey power leads & flat cable connector on old rev control board. Needs new rev electronics for the show.
- 2-5-09 : problems with ankle boot with battery insertion. could be pack or connector.
- 2-3-09 : power side motor mount shoulder bolt sheared
- 1-21-09 : replaced flex cable.
- 1-19-09 : tuned well with hugh, has new belt today
- 1-8-09 : brief test with Hugh and upright3 parameters. Delivered very little power, but could be tuning.
- 1-6-09 : Doesn't work with MCver CG6. Reinstalled CD6 from Dec 4. Probably should update to ~Dec 12 (tx demo)
- 12-31-08 : believed to be working from TX demo
- built with SC006, PB005. Problems with drive5 encoder.
- 12-4-08 : +20% series spring, with clamp in shows 2 detents (middle stiffness)
- 12-4-08 : Controller Upd_pcb#110-006 (has battery ECO)
- 12-1-08 : Controller Upd_pcb#110-009
- 12-1-08 : normal series spring with clamp in softest position
config
- Controller [Upd_pcb#200-004]]
- FET Upd_pcb#200-004
- Pyramid 5
- Drive10