Difference between revisions of "Wow left"
From DIDEAS Wiki
m |
m |
||
Line 5: | Line 5: | ||
− | =WOW proto2 (left)= | + | =WOW proto2 (left)=\ |
+ | *4-2-09 : replaced with rev 200 board set (#4 SC/MC and #4 power) | ||
+ | *4-1-09 : discovered has drive assembly #10 (not #6) | ||
+ | *4-1-09 : power board #5 TVS appears to have made contact with case causing solder and Cu trace to melt/vaporize. | ||
*2-5-09 : problems with ankle boot with battery insertion. could be pack or connector. | *2-5-09 : problems with ankle boot with battery insertion. could be pack or connector. | ||
*2-3-09 : power side motor mount shoulder bolt sheared | *2-3-09 : power side motor mount shoulder bolt sheared | ||
Line 21: | Line 24: | ||
==config== | ==config== | ||
− | *Controller [Upd_pcb# | + | *Controller [Upd_pcb#200-004]] |
− | *FET [[Upd_pcb# | + | *FET [[Upd_pcb#200-004]] |
*Pyramid 5 | *Pyramid 5 | ||
− | *[[Aiw_hardware# | + | *[[Aiw_hardware#drive_10 | Drive10]] |
Revision as of 04:48, 2 April 2009
=WOW proto2 (left)=\
- 4-2-09 : replaced with rev 200 board set (#4 SC/MC and #4 power)
- 4-1-09 : discovered has drive assembly #10 (not #6)
- 4-1-09 : power board #5 TVS appears to have made contact with case causing solder and Cu trace to melt/vaporize.
- 2-5-09 : problems with ankle boot with battery insertion. could be pack or connector.
- 2-3-09 : power side motor mount shoulder bolt sheared
- 1-21-09 : replaced flex cable.
- 1-19-09 : tuned well with hugh, has new belt today
- 1-8-09 : brief test with Hugh and upright3 parameters. Delivered very little power, but could be tuning.
- 1-6-09 : Doesn't work with MCver CG6. Reinstalled CD6 from Dec 4. Probably should update to ~Dec 12 (tx demo)
- 12-31-08 : believed to be working from TX demo
- built with SC006, PB005. Problems with drive5 encoder.
- 12-4-08 : +20% series spring, with clamp in shows 2 detents (middle stiffness)
- 12-4-08 : Controller Upd_pcb#110-006 (has battery ECO)
- 12-1-08 : Controller Upd_pcb#110-009
- 12-1-08 : normal series spring with clamp in softest position
config
- Controller [Upd_pcb#200-004]]
- FET Upd_pcb#200-004
- Pyramid 5
- Drive10