Difference between revisions of "Wip4a-spi"
From DIDEAS Wiki
m |
m |
||
| Line 2: | Line 2: | ||
==interface to ankle== | ==interface to ankle== | ||
| + | |||
===power=== | ===power=== | ||
*The hardware can be powered over the FUP port (WIP4a.PFUP1) or via the 3 pin header (WIP4a.PO3) | *The hardware can be powered over the FUP port (WIP4a.PFUP1) or via the 3 pin header (WIP4a.PO3) | ||
| Line 12: | Line 13: | ||
===SC Comm (MPD proto) === | ===SC Comm (MPD proto) === | ||
| − | * connect special 6 to 5 min 1.25mm cable to 6 pin connector (WIP4a.PX1) | + | * connect special 6 to 5 min 1.25mm cable (marked with orange/green strip on 6 pin housing) to 6 pin connector (WIP4a.PX1) |
* connect to normal (RED) 5 header on FUP1.pcb | * connect to normal (RED) 5 header on FUP1.pcb | ||
* connect 9 pin 1.00mm cable to STATE CONTROLLER PORT of [[Upd_2x0_218_controller | UPD 200-218 (SC/MC)]] | * connect 9 pin 1.00mm cable to STATE CONTROLLER PORT of [[Upd_2x0_218_controller | UPD 200-218 (SC/MC)]] | ||
Revision as of 23:28, 29 March 2009
Contents
wip4a w/spi
interface to ankle
power
- The hardware can be powered over the FUP port (WIP4a.PFUP1) or via the 3 pin header (WIP4a.PO3)
- The unit accepts 15-30 volts and requires ~ 2watts
MC Comm (Dataport)
- straight 1.25mm cable into 5 pin connector (WIP4a.PFUP1)
- connect to normal (RED) 5 header on FUP1.pcb
- connect 9 pin 1.00mm cable to MOTOR CONTROLLER PORT pf UPD 200-218 (SC/MC)
SC Comm (MPD proto)
- connect special 6 to 5 min 1.25mm cable (marked with orange/green strip on 6 pin housing) to 6 pin connector (WIP4a.PX1)
- connect to normal (RED) 5 header on FUP1.pcb
- connect 9 pin 1.00mm cable to STATE CONTROLLER PORT of UPD 200-218 (SC/MC)
