Difference between revisions of "Todo ca"
From DIDEAS Wiki
m |
m |
||
Line 1: | Line 1: | ||
+ | * diagnose cause of S3 failure (run the 217-009 through the bench test until there is a problem.) | ||
+ | * If [[Upd_2x0_217_power_board#200-217-005 | FET#5]] and [[Upd_2x0_218_controller#200-218-007 | SC#7]] successfully run overnight bench test - then install into S3. | ||
+ | |||
* take status of the 217 and 218 boards. | * take status of the 217 and 218 boards. | ||
− | ** we need a board set (217-218) for GG. | + | ** we need a board set (217-218) for GG. |
− | |||
− | |||
− | |||
− | |||
** diagnose and fix [[Upd_2x0_217_power_board#200-217-001 | FET#1]] | ** diagnose and fix [[Upd_2x0_217_power_board#200-217-001 | FET#1]] | ||
** try to repair other damaged SC/MC (218), and FET (217) boards. | ** try to repair other damaged SC/MC (218), and FET (217) boards. |
Revision as of 03:44, 30 October 2009
- diagnose cause of S3 failure (run the 217-009 through the bench test until there is a problem.)
- If FET#5 and SC#7 successfully run overnight bench test - then install into S3.
- take status of the 217 and 218 boards.
- we need a board set (217-218) for GG.
- diagnose and fix FET#1
- try to repair other damaged SC/MC (218), and FET (217) boards.
- keep records of which PCBs are in which robot units.
- make 9wire x 1mm straight cables. Suggest 8 and 10" length- suggest 2 to 4 of each. See example cable connecting S3 to new SWIFI (WIP4C). This will help GG.
- complete assembly of #2 WIP4c
- learn to program MPD boards, Swifis, and radios
- document status of PCAs Wip4c Pser2h
- make sure the both RE40-EC30 bench test units have good EC30s.
- probably rebuild one with an EC30-mile.
- build set of cables for the (old) SWIFI???
- what is the status of IMU#4 (no wiki entry) Upd_219_imu#4
notes
- expect missing 8x parts for Wip4c on Wed (or Tue)