Difference between revisions of "Biomech wireless"
From DIDEAS Wiki
m |
(→SWIFI LAN IPs) |
||
Line 29: | Line 29: | ||
=SWIFI LAN IPs= | =SWIFI LAN IPs= | ||
− | *S5 = | + | *S5 = 192.168.192.218 |
*S3 = 10.2.0.216 | *S3 = 10.2.0.216 | ||
+ | |||
+ | *Ankle 8 = 192.168.192.206 |
Revision as of 16:48, 26 September 2011
- BiomechDocs BL Knee PFresearchE
- Biomech Documentation links:
- AKCPU2z BLMD6c BLFT6c PSER1c Imu_2010 Emg_2009 Ric Upd_pcb
An access point for use by the robots has been setup. Verify that is operational at the following URL:
http://bmech4.media.mit.edu:8080/
(Note, you may need to just past it into your browser directly)
- From the AP status page (no password required), you will also be able to see if wireless devices have connected, along with their IP.
- User name is "admin", for password - should be written on the case.
Access to the private network
The wireless devices operate on a private network. To make a connection one of the following must be used:
- Connect to the LAN side of the AP
- Make a wireless connect to the AP with the PC.
- VPN into the AP
- Use port forwarding on the AP to direct incoming TCP connections to a specific IP on the LAN
Connection to SWIFI
- wifi_fast.py -i bmech4.media.mit.edu -V ak_p32 -f xx -F
- bmech4 is access point, with lan ip 10.2.0.251, uses DMZ to route traffic to a fixed LAN IP
- A 4 wire cable with pins 2,3 swapped is connected from PSW1 to the SWIFI port labeled M
- This interface is NOT isolated and can power the SWIFI
SWIFI LAN IPs
- S5 = 192.168.192.218
- S3 = 10.2.0.216
- Ankle 8 = 192.168.192.206