Difference between revisions of "Biomech wireless"
From DIDEAS Wiki
(→SWIFI LAN IPs) |
|||
Line 3: | Line 3: | ||
− | + | Two access points for use by the robots has been setup. Verify that one or both are operational at the following URLs: | |
− | |||
http://bmech4.media.mit.edu:8080/ | http://bmech4.media.mit.edu:8080/ | ||
+ | http://bmech6.media.mit.edu:8080/ | ||
(Note, you may need to just past it into your browser directly) | (Note, you may need to just past it into your browser directly) | ||
− | *From the AP status page (no password required), you will also be able to see if wireless devices have connected, along with their IP | + | *From the AP status page (no password required), you will also be able to see if wireless devices have connected, along with their IP: |
+ | **Wireless tab | ||
+ | ***Clients uner Wireless Nodes | ||
*User name is "admin", for password - should be written on the case. | *User name is "admin", for password - should be written on the case. | ||
Revision as of 16:51, 26 September 2011
- BiomechDocs BL Knee PFresearchE
- Biomech Documentation links:
- AKCPU2z BLMD6c BLFT6c PSER1c Imu_2010 Emg_2009 Ric Upd_pcb
Two access points for use by the robots has been setup. Verify that one or both are operational at the following URLs:
http://bmech4.media.mit.edu:8080/
http://bmech6.media.mit.edu:8080/
(Note, you may need to just past it into your browser directly)
- From the AP status page (no password required), you will also be able to see if wireless devices have connected, along with their IP:
- Wireless tab
- Clients uner Wireless Nodes
- Wireless tab
- User name is "admin", for password - should be written on the case.
Access to the private network
The wireless devices operate on a private network. To make a connection one of the following must be used:
- Connect to the LAN side of the AP
- Make a wireless connect to the AP with the PC.
- VPN into the AP
- Use port forwarding on the AP to direct incoming TCP connections to a specific IP on the LAN
Connection to SWIFI
- wifi_fast.py -i bmech4.media.mit.edu -V ak_p32 -f xx -F
- bmech4 is access point, with lan ip 10.2.0.251, uses DMZ to route traffic to a fixed LAN IP
- A 4 wire cable with pins 2,3 swapped is connected from PSW1 to the SWIFI port labeled M
- This interface is NOT isolated and can power the SWIFI
SWIFI LAN IPs
- S5 = 192.168.192.218
- S3 = 10.2.0.216
- Ankle 8 = 192.168.192.206