Difference between revisions of "Biomech wireless"
From DIDEAS Wiki
m |
m |
||
Line 2: | Line 2: | ||
*{{T_lab_pca}} | *{{T_lab_pca}} | ||
− | + | ||
− | An access point for use by the robots has been setup. | + | An access point for use by the robots has been setup. Verify that is operational at the following URL: |
http://bmech4.media.mit.edu:8080/ | http://bmech4.media.mit.edu:8080/ | ||
Line 10: | Line 10: | ||
− | = | + | =Access to the private network= |
The wireless devices operate on a private network. To make a connection one of the following must be used: | The wireless devices operate on a private network. To make a connection one of the following must be used: | ||
* Connect to the LAN side of the AP | * Connect to the LAN side of the AP | ||
Line 18: | Line 18: | ||
− | + | =Connection to SWIFI= | |
*wifi_fast.py -i bmech4.media.mit.edu -V ak_p32 -f xx -F | *wifi_fast.py -i bmech4.media.mit.edu -V ak_p32 -f xx -F | ||
*bmech4 is access point, with lan ip 10.2.0.251, uses DMZ to route traffic to a fixed LAN IP | *bmech4 is access point, with lan ip 10.2.0.251, uses DMZ to route traffic to a fixed LAN IP | ||
Line 25: | Line 25: | ||
− | + | =SWIFI LAN IPs= | |
*S5 = 10.2.0.218 | *S5 = 10.2.0.218 | ||
*S3 = 10.2.0.216 | *S3 = 10.2.0.216 |
Revision as of 14:47, 6 October 2010
- BiomechDocs BL Knee PFresearchE
- Biomech Documentation links:
- AKCPU2z BLMD6c BLFT6c PSER1c Imu_2010 Emg_2009 Ric Upd_pcb
An access point for use by the robots has been setup. Verify that is operational at the following URL:
http://bmech4.media.mit.edu:8080/
From the AP status page (no password required), you will also be able to see if wireless devices have connected, along with their IP.
Access to the private network
The wireless devices operate on a private network. To make a connection one of the following must be used:
- Connect to the LAN side of the AP
- Make a wireless connect to the AP with the PC.
- VPN into the AP
- Use port forwarding on the AP to direct incoming TCP connections to a specific IP on the LAN
Connection to SWIFI
- wifi_fast.py -i bmech4.media.mit.edu -V ak_p32 -f xx -F
- bmech4 is access point, with lan ip 10.2.0.251, uses DMZ to route traffic to a fixed LAN IP
- A 4 wire cable with pins 2,3 swapped is connected from PSW1 to the SWIFI port labeled M
- This interface is NOT isolated and can power the SWIFI
SWIFI LAN IPs
- S5 = 10.2.0.218
- S3 = 10.2.0.216