AIW assembly

Power connectors

TEST ALL MALE BULLET CONNECTORS See example of how this device fails.

• Use 3.5mm male bullet connectors on the motor.
• Use 3.5mm male bullet connectors on the output of the WOW battery pack
• Use 3.5mm female connectors on the power board

SC/MC testing

• apply power with FUP power cable to MC FUP.
• connect wired (or BT) to SC FUP

FET testing

• connect FET to known good SC/MC with flex cable.

pyramid verification

• connect P to working SC

run over night test

• stress test a board set mounted in side plates
• using mode 7, measure the current offsets and record. copy values into statemachine.h

assembly

• run motor tests over night, installed in side plates
• actuator - measure / adjust belt tension - record value and date it.

• run BT communications wire

before K3

• insert both programming cables
• wait to install K3 last, VHB copper spreader to K3 (might fall out otherwise)
• red lock tight pyramid tube adapter into WOW pack

• connect BT mod to flexF midpoint, make sure to correct module for left vs right.