Difference between revisions of "Wip4a-spi"
From DIDEAS Wiki
m (→SWIFI PCB status) |
m (→SWIFI PCB status) |
||
Line 11: | Line 11: | ||
*2 7-2-09 : overvoltage event. dsPIC seems to have smoke holes. (has radio 00-20-4a-9f-99-86 : 10.0.0.7) | *2 7-2-09 : overvoltage event. dsPIC seems to have smoke holes. (has radio 00-20-4a-9f-99-86 : 10.0.0.7) | ||
*3 works - but has trace damage - used w/Spalding (9-17-09) | *3 works - but has trace damage - used w/Spalding (9-17-09) | ||
− | *4 works - but has trace damage status unknown | + | *4 works - but has trace damage status unknown, 10-24-09 used w/LF |
*5 works - but has trace damage : 7-3-09 programmed w/latest firmwire. 10-24-09 works | *5 works - but has trace damage : 7-3-09 programmed w/latest firmwire. 10-24-09 works | ||
*6 not working. damaged traces at edge of PCA needs to be fixed | *6 not working. damaged traces at edge of PCA needs to be fixed |
Revision as of 00:12, 25 October 2009
- PF Users Navigation:
- PCB; Lifefix_users; Pf_users; benchtest_users; CalibFix Users; Hardware; Assembly ; iochan ;
- PCA : PCB ; AKENC SC/MC 218 ; FET 217 ; IMU219 ; Swifi ; Rev200_mods ; PCA Inventory
- Special Commands to the Ankle (PFCMD) : State Controller Commands; Motor Controller Commands; Python Examples; IMU Commands ;PFCMD_PY; Pf_calb_table_py; Virtual spring test; PF EEPROM
- DOC: Pf_users; Powerfoot Keyboard User Interface; Steps for Manual Tuning; "Dashboard" Program For Assisting with Tuning
- NEW (CEB) WIKI
- Torque Feedback Controller Guide
- pser2h ; pser2h-b ; pser1 ; FUPs ; ldwash1 ; ldwash2 ; ; Vclamp8 ; dclamp1 ; dclamp2 ; wip4a-spi ; wip4c
SWIFI PCB status
All radios only tested on primary port (5pin / PFUP1)
- 1 works well - used w/Spalding (9-17-09)
- 2 7-2-09 : overvoltage event. dsPIC seems to have smoke holes. (has radio 00-20-4a-9f-99-86 : 10.0.0.7)
- 3 works - but has trace damage - used w/Spalding (9-17-09)
- 4 works - but has trace damage status unknown, 10-24-09 used w/LF
- 5 works - but has trace damage : 7-3-09 programmed w/latest firmwire. 10-24-09 works
- 6 not working. damaged traces at edge of PCA needs to be fixed
assembly docs
software notes
- hardware_config.h sets PLL MULT and SCALE to result in 14.74 Mhz * (74+2)/(5+2) = 40.024Mhz
- DSPIC UARTs connect to SC/MC
- SPI UART connects to WIPORTb