Difference between revisions of "Calb algs"
From DIDEAS Wiki
m |
m |
||
Line 1: | Line 1: | ||
− | {{ | + | {{Pf_top_nav}} |
− | ==key | + | ==key EC30_MILE_AT_ZERO_Axxxx_ANGLE== |
− | *Motor needs to be on the bench (outside of robot) | + | This calibration has the motor leads open and the "robot" is driven to the zero angle by the calb stand motor. |
− | *Enter mode 2 | + | * move "robot" from random inital position to the nominal zero angle position |
− | *allow motor to settle and record MILE | + | * allow to settle and record the MILE encoder value |
+ | * repeat several times | ||
+ | * the average MILE encoder reading is assigned to the above key. | ||
+ | |||
+ | |||
+ | |||
+ | ==key EC30_MILE_AT_ZERO_MOTOR_ANGLE== | ||
+ | Motor needs to be on the bench (outside of robot), power supply is ~24V | ||
+ | *Enter mode 2 with moderate voltage (special command 1115 1000 0 2) | ||
+ | *allow motor to settle and record MILE encoder value | ||
*move motor slighly and repeat | *move motor slighly and repeat | ||
*there *should* be two stable position and two clusters of MILE encoder values (separated by 1024) | *there *should* be two stable position and two clusters of MILE encoder values (separated by 1024) | ||
*use the smaller of the two numbers for the key | *use the smaller of the two numbers for the key |
Latest revision as of 17:39, 5 June 2010
PF Users Navigation:
- PCB; Lifefix_users; Pf_users; benchtest_users; CalibFix Users; Hardware; Assembly ; iochan ;
- PCA : PCB ; AKENC SC/MC 218 ; FET 217 ; IMU219 ; Swifi ; Rev200_mods ; PCA Inventory
- Special Commands to the Ankle (PFCMD) : State Controller Commands; Motor Controller Commands; Python Examples; IMU Commands ;PFCMD_PY; Pf_calb_table_py; Virtual spring test; PF EEPROM
- DOC: Pf_users; Powerfoot Keyboard User Interface; Steps for Manual Tuning; "Dashboard" Program For Assisting with Tuning
- NEW (CEB) WIKI
- Torque Feedback Controller Guide
key EC30_MILE_AT_ZERO_Axxxx_ANGLE
This calibration has the motor leads open and the "robot" is driven to the zero angle by the calb stand motor.
- move "robot" from random inital position to the nominal zero angle position
- allow to settle and record the MILE encoder value
- repeat several times
- the average MILE encoder reading is assigned to the above key.
key EC30_MILE_AT_ZERO_MOTOR_ANGLE
Motor needs to be on the bench (outside of robot), power supply is ~24V
- Enter mode 2 with moderate voltage (special command 1115 1000 0 2)
- allow motor to settle and record MILE encoder value
- move motor slighly and repeat
- there *should* be two stable position and two clusters of MILE encoder values (separated by 1024)
- use the smaller of the two numbers for the key