Difference between revisions of "POT4"
From DIDEAS Wiki
Line 6: | Line 6: | ||
* Maximum supply voltage is +-15V | * Maximum supply voltage is +-15V | ||
− | == | + | == Identification == |
*POT4 is a green PCB with white silk screen. | *POT4 is a green PCB with white silk screen. | ||
− | * | + | *Dimensions 1.75" x 0.85" |
*Two mounting holes (diameter = 0.125"), top side clearance > 0.25" | *Two mounting holes (diameter = 0.125"), top side clearance > 0.25" | ||
− | *The color of DL1,DL2 indicates the input | + | *The color of DL1,DL2 indicates the input configuration of the board |
==Led Indicators== | ==Led Indicators== | ||
*(DL1, DL2) : A pair of single LEDs indicate the present of power. These LEDs are aligned with the power input to the boards. | *(DL1, DL2) : A pair of single LEDs indicate the present of power. These LEDs are aligned with the power input to the boards. | ||
− | **RED : configured for | + | **RED : configured for potentiometer inputs (#1-2) |
**GREEN : configured with bridge inputs (#3-8) | **GREEN : configured with bridge inputs (#3-8) | ||
− | *DK1 : The intensity of this dual RED/GREEN LED indicates the voltage of the " | + | *DK1 : The intensity of this dual RED/GREEN LED indicates the voltage of the "position signal". |
==Jumpers== | ==Jumpers== | ||
− | * JF1 : 3 way jumper used to select | + | * JF1 : 3 way jumper used to select source that drives that "Position" output. The signal source may be one of the following: |
− | ** | + | **Instrumentation amplifier output |
**2nd order low pass filter output | **2nd order low pass filter output | ||
**4th order low pass filter output | **4th order low pass filter output |
Revision as of 03:38, 2 June 2005
Contents
Power Supply
- +12V, GND, -12V required.
- Supply current < 50mA
- Maximum supply voltage is +-15V
Identification
- POT4 is a green PCB with white silk screen.
- Dimensions 1.75" x 0.85"
- Two mounting holes (diameter = 0.125"), top side clearance > 0.25"
- The color of DL1,DL2 indicates the input configuration of the board
Led Indicators
- (DL1, DL2) : A pair of single LEDs indicate the present of power. These LEDs are aligned with the power input to the boards.
- RED : configured for potentiometer inputs (#1-2)
- GREEN : configured with bridge inputs (#3-8)
- DK1 : The intensity of this dual RED/GREEN LED indicates the voltage of the "position signal".
Jumpers
- JF1 : 3 way jumper used to select source that drives that "Position" output. The signal source may be one of the following:
- Instrumentation amplifier output
- 2nd order low pass filter output
- 4th order low pass filter output
- JC1 : selects the "Shield" header signal source and is specified at assembly time. Signal sources include "GND", "COM", or "REF-".
assembly variations
POT4 can be built for either potentiometer input or bridge input. There are also several optional circuit modules.
- boards #1, #2 : fully built with lowpass filters, differentiation is configured for potentiometer input
- boards #3, #4 : minimally built for strain gauge bridge input
- boards #5 - #8: built for strain gauge bridge input and are minimally built with 2nd order LP filter