Difference between revisions of "BATPTC1"
From DIDEAS Wiki
m |
m (→identification) |
||
| Line 10: | Line 10: | ||
[[image:batptc1-pcb-b.png|right|thumb|80px|bottom side]] | [[image:batptc1-pcb-b.png|right|thumb|80px|bottom side]] | ||
*labeled "ankle-v3/batptc1.pcb", "091006" | *labeled "ankle-v3/batptc1.pcb", "091006" | ||
| − | *2.1 x 1" inch AP Circuits PCB | + | *2.1 x 1" inch AP Circuits PCB |
| + | |||
| + | =bill of materials= | ||
| + | 1 PB1 dean's ultra plug | ||
| + | 1 PB2 277-1011-ND 2 position 0.2" terminal block Phoenix contact | ||
| + | 1 CVX1 tant 7243 | ||
| + | 1 DB1 15V zener, SOD-123 | ||
| + | 1 QB1 BSS 83P SOT-23 P channel | ||
| + | 1 RB1 10 Meg 0805 | ||
| + | 1 UBI1 INA168 High side current amp, SOT23-5 | ||
| + | |||
| + | |||
| + | |||
| + | 277-1011-ND is 2-pos, 0.2" terminal plug | ||
=design files= | =design files= | ||
*[[Media:batptc1-sch.pdf]] | *[[Media:batptc1-sch.pdf]] | ||
Revision as of 21:34, 18 September 2006
Part of the Ankle_0806 project:
JANK1 | BENCH2 | BENCH2F | BATPTC1 | BATMRG1 | BPWR1 | POT4a | QAKAMP
Protects LiIon cells by cutting off load when cells fall below cutoff voltage. Also implements current monitoring, and electronic circuit breaker.
identification
- labeled "ankle-v3/batptc1.pcb", "091006"
- 2.1 x 1" inch AP Circuits PCB
bill of materials
1 PB1 dean's ultra plug 1 PB2 277-1011-ND 2 position 0.2" terminal block Phoenix contact 1 CVX1 tant 7243 1 DB1 15V zener, SOD-123 1 QB1 BSS 83P SOT-23 P channel 1 RB1 10 Meg 0805 1 UBI1 INA168 High side current amp, SOT23-5
277-1011-ND is 2-pos, 0.2" terminal plug
