Difference between revisions of "Ankle 0806"
From DIDEAS Wiki
m (→Optical Encoder Motor Shaft) |
m (→Linear Pot) |
||
| Line 3: | Line 3: | ||
===Linear Pot=== | ===Linear Pot=== | ||
| − | |||
| − | |||
| − | + | *Novotechnik ptn025 see spec sheet attached to email | |
| − | |||
| − | |||
| − | |||
| − | |||
| + | shield : not connected at pot | ||
| + | red : 5v | ||
| + | black : gnd | ||
| + | white : signal | ||
| + | green : NOT connected | ||
===Motor === | ===Motor === | ||
Revision as of 19:28, 1 August 2006
Contents
Sensors
Linear Pot
- Novotechnik ptn025 see spec sheet attached to email
shield : not connected at pot red : 5v black : gnd white : signal green : NOT connected
Motor
Link to motor page and specs : Maxon motor number 305013 24v 200w
Motor power
- 3 wires 18 AWG
RED : Motor winding 1 BLACK : Motor winding 2 WHITE : Motor winding 3
brake
- 2 thin wires coming out of the silver unit on the back of the motor. This is the brake but there aren't any specs online only in the printed catalog??? go figure. There should be a catalog in lab.
blue : GND red : +24v
motor hall sensor
- 5 thin wires (hall sensors - 26 AWG)
blue : GND green : hall supply 4.5 to 20V red-grey : hall sensor 1 black-grey : hall sensor 2 white-grey : hall sensor 3
Optical Encoder Motor Shaft
Specs : HEDS
black : GND red : +5 blue : Ch A orange : Ch B white : Index
Ankle Position Encoder
Specs: US Digital HEDS Cui MG30
Red : +5 Yellow : Ch B Black : GND Grey : Ch A Orange : Ch Z
