AIW assembly

PF Users Navigation:

• PCB; Lifefix_users; Pf_users; benchtest_users; CalibFix Users; Hardware; Assembly ; iochan ;
• PCA : PCB ; AKENC SC/MC 218  ; FET 217 ; IMU219 ; Swifi ; Rev200_mods  ; PCA Inventory
• Special Commands to the Ankle (PFCMD) : State Controller Commands; Motor Controller Commands; Python Examples; IMU Commands ;PFCMD_PY; Pf_calb_table_py; Virtual spring test; PF EEPROM
• DOC: Pf_users; Powerfoot Keyboard User Interface; Steps for Manual Tuning; "Dashboard" Program For Assisting with Tuning
• NEW (CEB) WIKI
• Torque Feedback Controller Guide

Edit

SCREWS

• • IMU PCB mount 50 mills
  • side plates (sholder screws) : 2.5mm
  • K2 spring to ball nut / actuator : 2mm
  • K3 spring : 7/64"
  • front / back cover : 5/64"
  • belt tension adjust : 50 mills

AIW_preassembly

BT / Swiffy

• Using FUP1 board, interface 9pin Rev 200 FUP to BT FUP
  • Connect BT to FUP1 w/ 5pin straight cable, into the RED (straight) header.
• run BT communications wire

before K3

• insert both programming cables
• wait to install K3 last, VHB copper spreader to K3 (might fall out otherwise)
• red lock tight pyramid tube adapter into WOW pack

• connect BT mod to flexF midpoint, make sure to correct module for left vs right.