Difference between revisions of "Upd pcb"
From DIDEAS Wiki
m |
m |
||
| Line 1: | Line 1: | ||
| + | =State / Motor Controller= | ||
| − | = | + | ==110-009 (BF1) === |
| + | *11-26-08 : operational | ||
| + | *11-20-08 : Needs the 24 pin flex connect to be replaced. (replaced 11-25-08) | ||
| + | *11-19-08 : Needs battery measurement modification. | ||
| + | *11-8-08 : has jumper wire to turn self on, but wouldn't boot until IMU attached. After first power, remove IMU and works fine. | ||
| + | |||
| + | ==TODO== | ||
| + | * needs [[battery voltage ECO]] | ||
=Power Board= | =Power Board= | ||
| Line 11: | Line 19: | ||
===todo=== | ===todo=== | ||
| − | * change gate drive | + | * change gate drive resistors to 5.6 and at schottky |
Revision as of 22:22, 26 November 2008
Contents
State / Motor Controller
110-009 (BF1) =
- 11-26-08 : operational
- 11-20-08 : Needs the 24 pin flex connect to be replaced. (replaced 11-25-08)
- 11-19-08 : Needs battery measurement modification.
- 11-8-08 : has jumper wire to turn self on, but wouldn't boot until IMU attached. After first power, remove IMU and works fine.
TODO
- needs battery voltage ECO
Power Board
110-004
- 11-26-08 : benched tested for 3 days.
- 11-26-08 : has 2.0 ohm gate drive
- 11-26-08 : has 225W TVS on bypass caps.
todo
- change gate drive resistors to 5.6 and at schottky
