Difference between revisions of "QAKAMP"
From DIDEAS Wiki
m (→SN1 : assembly notes) |
m (→Rev A) |
||
Line 11: | Line 11: | ||
*LM358 and OP27 opamp power wired backwards - corrected in Rev B schematic | *LM358 and OP27 opamp power wired backwards - corrected in Rev B schematic | ||
*V- LED wired backwards in SCH, corrected in Rev B sch | *V- LED wired backwards in SCH, corrected in Rev B sch | ||
+ | *L.COM at REF- is open circuit - connected to COM | ||
==SN1 : assembly notes== | ==SN1 : assembly notes== | ||
*Vref built with TL1431, Ra=2.49, Rb=4.7k -> Vref = 7.2v | *Vref built with TL1431, Ra=2.49, Rb=4.7k -> Vref = 7.2v | ||
*RR1,RR4 are 4.7 and 10k. Wonder if smaller values might start regulation sooner. | *RR1,RR4 are 4.7 and 10k. Wonder if smaller values might start regulation sooner. |
Revision as of 02:06, 8 May 2006
Back to BM Ankle Tech notes Greddy IMU amplifer (GIMUAMP) Ankle MM32 breakout (AKBRK)
QAKAMP contains four bridge amplifiers with 2+ pole LP filters and differential output drivers, a high current precision voltage reference, power supply conditioning. The front end uses instrumentation amplifier with 80dB CMR extending to 100KHz.
Rev A
- LM358 and OP27 opamp power wired backwards - corrected in Rev B schematic
- V- LED wired backwards in SCH, corrected in Rev B sch
- L.COM at REF- is open circuit - connected to COM
SN1 : assembly notes
- Vref built with TL1431, Ra=2.49, Rb=4.7k -> Vref = 7.2v
- RR1,RR4 are 4.7 and 10k. Wonder if smaller values might start regulation sooner.