Difference between revisions of "POT4a"
From DIDEAS Wiki
m |
|||
| Line 1: | Line 1: | ||
Also see : [[POT4]] amd [[POT4b]] | Also see : [[POT4]] amd [[POT4b]] | ||
| + | |||
| + | ==Power Supply== | ||
| + | * +12V, GND, -12V recommend | ||
| + | * Supply current < 50mA (20mA typical) | ||
| + | * Maximum supply voltage is +-15V | ||
| + | |||
| + | == Identification == | ||
| + | |||
| + | [[image:Rpot4a-pcb-top-reva-062205.png|right|thumb|80px|top side]] | ||
| + | [[image:Rpot4a-pcb-bot-reva-062205.png|right|thumb|80px|bottom side]] | ||
| + | |||
| + | *POT4a is a green PCB with white silk screen on two sides. | ||
| + | *Dimensions 1.75" x 0.85" | ||
| + | *Two mounting holes (diameter = 0.125"), top side clearance > 0.25" | ||
| + | *The color of DL1,DL2 indicates the input configuration of the board | ||
| + | <br><p><br> | ||
| + | |||
| + | ==Led Indicators== | ||
| + | *(DL1, DL2) : A pair of single LEDs indicate the present of power. These LEDs are aligned with the power input to the boards. | ||
| + | *DK1 : The intensity of this dual RED/GREEN LED indicates the voltage of the "position signal". | ||
| + | |||
| + | |||
| + | |||
==revisions from POT4== | ==revisions from POT4== | ||
Revision as of 16:51, 22 June 2005
Power Supply
- +12V, GND, -12V recommend
- Supply current < 50mA (20mA typical)
- Maximum supply voltage is +-15V
Identification
File:Rpot4a-pcb-top-reva-062205.png
top side
File:Rpot4a-pcb-bot-reva-062205.png
bottom side
- POT4a is a green PCB with white silk screen on two sides.
- Dimensions 1.75" x 0.85"
- Two mounting holes (diameter = 0.125"), top side clearance > 0.25"
- The color of DL1,DL2 indicates the input configuration of the board
Led Indicators
- (DL1, DL2) : A pair of single LEDs indicate the present of power. These LEDs are aligned with the power input to the boards.
- DK1 : The intensity of this dual RED/GREEN LED indicates the voltage of the "position signal".
revisions from POT4
- add 5pin, 1.25mm header for strain gague
- removed unused input resistors and capacitors
- On POT4 a 1meg resistor was stacked on CC3 - this resistor added to SCH and PCB
- removed 4th order filter, changed 3way jumper to 2way
- 2nd order filter is now NON-Inverting
- input cable shield can be connected to COM via 0603 resistor
- changed PCB pattern for output driver caps to CAP200-SQ (acurately represents compoent shape)
- changed 0805 output cable CAP to 1206. Panasonic X5R series @ 25V 1uf to 10uF!
- added 10 turn POT for variable gain (optional)
- change CD2 (0.1u in derivative circuit) to 1206 size (was 0805)
