Difference between revisions of "Biomechatronics Documentation"
From DIDEAS Wiki
m (→misc) |
m (→BOARDS) |
||
| Line 4: | Line 4: | ||
==BOARDS== | ==BOARDS== | ||
| + | *[[JANK1]] | ||
| + | *[[BENCH2]] | ||
| + | *[[BENCH2F]] | ||
| + | *[[BATPTC1]] | ||
| + | *[[BATMRG1]] | ||
| + | *[[BATPWR1]] | ||
| + | |||
| + | |||
*[[QAKAMP | Ankle Quad Amplifer]] Four improved POT2b boards on a board. (QAKAMP) | *[[QAKAMP | Ankle Quad Amplifer]] Four improved POT2b boards on a board. (QAKAMP) | ||
*[[GIMUAMP | Greddy IMU Amplifer]] Six IA channels and linear supply for powering Greddy IMU (GIMUAMP) | *[[GIMUAMP | Greddy IMU Amplifer]] Six IA channels and linear supply for powering Greddy IMU (GIMUAMP) | ||
Revision as of 08:44, 14 September 2006
To edit this wiki you may use the user name and password "biomech".
BOARDS
- Ankle Quad Amplifer Four improved POT2b boards on a board. (QAKAMP)
- Greddy IMU Amplifer Six IA channels and linear supply for powering Greddy IMU (GIMUAMP)
- Ankle MM32 breakout MM32 breakout board for ankle. Connects to QAKAMP and GIMUAMP + access to other MM32 signals
- POT2 potentiometer input with instrumentation
- POT2a potentiometer input to instrumentation amp on yellow PCB
- POT2b potentiometer input to instrumentation amp on green PCB
- POT2c (in progress) has 4 pin, 1.25 mm header for bridge input OR 3 pin 0.1" header for POT input
- POT4 (all assembly variations)
- POT4a potentiometer only amplifier
- POT4b strain gague only amplifier
- MM32 breakout board REV-A
- MM32 breakout baord REV-B
- MM32 breakout baord REV-C : (in progress) Corrected SCH issue in RevB and rerun
- Copley / Accelnet Micro Module breakout board
- Copley / Accelnet Micro Module breakout board Rev A (in progress)
- PID1 Analog PID controller with local power supply
